Upgrade to 2.10 using built in tool CDR is missing
I used the upgrade module to upgrade to 2.10
screenshot:
http://www.webpagescreenshot.info/img/867374-124201293810PM
CDR is now missing. There are no menu options to access it. All of the other modules are there and working fine.
Any suggestions?
Thanks
__________________
News Announcements
New Forum Topics
- How can I avoid simultaneous outbound calls to the same cell phone nr? (Internetcalls.com, betamax)
- Configuring DAHDi useing FreePBX 2.10.0.7
- Where is externip stored?
- Can i just change the IP Address?
- Can not make or receive calls.. Please help..
- Cannot Transfer outbound calls
- Error Exit:1
- Logged in: USERNAME (Logout) link missing
- Upgrade Asterisk 1.4.42 to 1.8
- Problem
- [Working!] Cisco XML Directory with LDAP lookup to iCloud
- Codac g729 error
How was the original install
How was the original install done? FreePBX distro or build be hand? For the distro you should use the upgrade scripts and for a built by hand system you should use the module upgrade.
The original install was run
The original install was run by hand. It was a base centos install and then freepbx install script was run on top a clean LAMP + asterisk 1.8 stack.
CDR's were removed from
CDR's were removed from framework. Install the CDR module.
Moshe Brevda, FreePBX/Schmooze Com Development Team
I had the exact same
I had the exact same problem. Upgrading from 2.9 to 2.10 using module admin. I had to download freepbx 2.10, extract the CDR module, and manually upload it into my freepbx installation and then it showed up in module admin and I was able to install it. This looks like a bug to me.